Step 1
Open the box and make sure you read the instructions found behind the top lid.
Step 2
Take out one half of the tenting kit by lifting the handles on each side.
Step 3
Now take out the other half.
Step 4
Place all the components on the table; you should have a screwdriver and 10 screws, and the right and left halves of the tenting kit.
Step 5
Split your Raise keyboard and start with one side. At the back of the Raise, there are 7 screws, but you have to unscrew only the top 5.
Step 6
Place the tenting kit at the back, make sure you put the right side on the right keyboard. And the left side on the left keyboard. Then screw in the screws. Use the ones that came with the tenting kit. These screws are different from the ones originally on your Raise.
Step 7
Do this for the other side. Make sure the screws are tight enough but not extremely tight.
And voilà, you have successfully mounted your tenting kit.
A few things to remember:
- First, when changing angles, make sure the axle is inserted properly into the angle selector. Don't be afraid to apply a bit of force; this tenting kit is very sturdy.
- Second. These rubber feet are removable, so make sure they're also inserted properly.
- And finally, you can fit the Raise inside your travel case. You might need to adjust it a bit so you can close the lid, but the materials of the travel case are flexible enough for you to fit your Raise and tenting kit in it.
